User's Manual

Page 53
1-12
Installation & Operation Manual
High/Low Options
Tap High/Low Options on the Settings Menu to display the
settings for high or low readings.
Advance on High/Low: The next account displays after a
high or low reading.
Beep on High/Low: An audible alert sounds for a high or low
reading.
Show High/Low Values: Displays the high and low values on
the screen. If the values are set NOT to display by the reading
data management software operator, changing the option
on this screen will not aect the setting.
Figure 70: High/Low Reading Options
Hi/Low Readings Fail: When checked, a reading is considered high or low if it MATCHES the high or low value. Unchecked,
the high reading must be HIGHER and the low reading must be LOWER.
High/Low Entry Disposition: The High/Low Options screen opens so you can manually enter reading information.
Displayable Field Settings
Tap Displayable Field Settings on the Settings Menu to see
the User Defined Fields screen. This screen displays the
pre-defined fields that display on the Read screen.
The rst ve eld settings are determined by the reading data
management operator. These elds cannot be changed.
The sixth (Custom) eld may be changed by the meter
reader. Refer to "Read Screen" on page 24 for additional
information.
Tap Custom Fields to display the options for the Custom
Field (Figure 72).
Figure 71: Read Screen Fields
Use the up and down arrows to scroll. Then tap to select the desired option. In Figure 72, Module SN is chosen to display in
the Custom eld.
Tap Select. The User Dened Fields screen reopens and the new selection displays below the Custom Fields button and on
the Read screen.
Figure 72: Custom Field Options
Figure 73: Custom Field Changed