User's Manual
Table Of Contents
- Introduction
- Glossary
- Trimble Ranger Handheld Overview
- Conserving the Battery
- Charging the Handheld Battery
- Handheld Setup for Reading Both ORION ME and ORION CE Endpoints
- Handheld Basic Operations
- Swapping the Battery Pack (Low Battery)
- General Care of the Handheld
- Using the Touch Screen
- Program Startup
- Copyright Screen
- Main Menu
- Reading a Route
- Manual Reads
- Read Results
- Read Menu
- Comments
- Read Direction
- View High/Low
- Manual Read
- _
- Utilities
- Route Info
- Program & Quick Read
- ORION CE
- ORION ME/SE Utility
- Utilities
- PROGRAMMING AN ORION GAS MODULE
- Appendix
- Using the Handheld Keypad
- Hot Keys and Quick Keys
- Technical Support
Page 55
1-12
Installation & Operation Manual
PROGRAMMING AN ORION GAS MODULE
Gas meters are programmed using ORION ME/SE Utility software.
1. From the Main Menu tap Program & Quick Read.
2. Tap to choose ORION ME, then tap Open.
Result: The ORION ME/SE Utility screen opens.
Figure 77: Main Menu
Figure 78: Select ORION ME
3. Tap the IR tab to access the ORION programming
software.
4. Connect the IR cable to the 9-pin serial port on the
bottom of the handheld.
5. Align the IR cable with the gas endpoint. Then tap
Read on the ORION ME/SE Utility screen.
Result: The Gas Drive Circle window opens.
Figure 79: ME/SE Utility Programming
6. Tap Ye s to select a Gas Drive Circle.
Figure 80: Select a Drive Circle