User's Manual
Table Of Contents
- Introduction
- Glossary
- Trimble Ranger Handheld Overview
- Conserving the Battery
- Charging the Handheld Battery
- Handheld Setup for Reading Both ORION ME and ORION CE Endpoints
- Handheld Basic Operations
- Swapping the Battery Pack (Low Battery)
- General Care of the Handheld
- Using the Touch Screen
- Program Startup
- Copyright Screen
- Main Menu
- Reading a Route
- Manual Reads
- Read Results
- Read Menu
- Comments
- Read Direction
- View High/Low
- Manual Read
- _
- Utilities
- Route Info
- Program & Quick Read
- ORION CE
- ORION ME/SE Utility
- Utilities
- PROGRAMMING AN ORION GAS MODULE
- Appendix
- Using the Handheld Keypad
- Hot Keys and Quick Keys
- Technical Support
Page 56
1-12
ORION® Automated Meter Reading System for Trimble® Ranger™
Result: The Gas Endpoint Status screen opens. All
detected statuses will have a check mark.
7. Tap Drive Circle Info.
Figure 81: Endpoint Status
8. Select All, Integral or Remote to narrow down the options. Narrow down the selection further by choosing Units,
Resolution and Dials.
Figure 82: Drive Circle Selection Integral/Remote
Figure 83: Drive Circle Selection Units
Figure 84: Drive Circle Selection Resolution
Figure 85: Drive Circle Selection Dials
9. Tap to highlight the appropriate Gas Drive Circle. Then tap Select.