Manual

Figure 2: Measuring element assembly, 8"
SERVICING PARTS AND ASSEMBLIES
This section contains information about general maintenance and servicing. Instructions for disassembling the Recordall
Turbo Series mainline meter for servicing can be found in the Recordall Turbo Series Meter User Manual. Also see the Recordall
Combo Meter Parts List for part numbers of replaceable components and correct ordering information. If satisfactory repair
cannot be made, contact Badger Meter.
Instructions for servicing the Disc Series bypass meter can be found in the Recordall Disc Series Meter User Manual. Component
detail can be found in the Recordall Disc Series Meter Parts List.
When the performance of the Combo Meter indicates a need for servicing of the Recordall Turbo Series meter, refer to the
following instructions pertaining to removal, inspection and installation of service parts and assemblies. With the Recordall
Turbo Series unitized construction, service is simplified with a reduction in required product maintenance training. Also see
the Recordall Turbo Series Meter Parts List for part numbers of replaceable components for ordering information. If satisfactory
repair cannot be made, contact Badger Meter.
Maintenance
Badger Meter products have been carefully designed to be as maintenance-free as possible. However, depending upon
installation location and condition of water being metered, maintenance may occasionally be required. The maintenance
and inspection procedure can also be used as a guide to locating a problem in the unit that may be the cause of abnormal
meter operation.
Meters can be serviced without removing them from the line. A typical installation would be equipped with drain and piping
valves. To inspect or replace components of the head assembly for the turbo or the chamber assembly in the disc meter,
close the upstream and downstream valves. However, if the installation does not have a drain valve, proceed as follows to
relieve pressure:
Recordall® Combo Meter, 8"
Page 8 October 2013