Owner's manual

SRD960 with FOUNDATION Fieldbus:
Menu 10: FF Configuration
M1 234
½- -½½M,LED3and LED4 flash
Special settingsfor FoundationFieldbus device.
10.1Simulate enable /disable
¼¾ ---Mshort flash, LED1long flash
TheSRD960sends during normaloperation its actualPosition-Actual-
Value
1)
back to thecontrolsystem.
If, however,“Simulate” is released in theSRD andinadditionvia communi-
cation Simulate is activated, then asimulationvalue coming from thecontrol
system is sentbackasanactual value to thecontrol system.Inthisway
within thecontrol system, e.g. thereactiontospecificvalve adjustments can
be tested withouthavingtoadjustthe valve–theSRD regulatestowardthe
”accurate” setpointvalue.
Forfurther information about theSimulatesee TI EVE0105Q.
10.1.1Simulate Disabled
-1--- LED1lightsup
Disablesimulate. The realvalveposition will be indicated.
10.1.2Simulate Enabled
----1 LED4lightsup
Releasesimulate.
10.2 Foundation FieldbusProfile: Activate LinkMaster
¼-¾- -Mshortflash,LED 2 longflash
10.2.1 Link Master active
-1--- LED1lights up
This SRD becomes theLink MasterifControl Systemis down.
10.2.2Basicdevice
----1 LED4lightsup
This SRD becomes not theLink MasterifControl System is down.
By using theUPorDOWN keys the desired condition can be selected and
entered throughpressing keys UP+DOWN.
1) With theoption ”Position Feedback”,the position-actual-value willbedisplayed, as before,
as analog value4to 20 mA.
SRD Main Menu
8 Setpoint
9 Workbench
10 FF Config
10 FF Config
10.1 Simulate
10.2 Profile
10.1 Simulate
10.1.1 Disabled
10.1.2 Enabled
10 FF Config
10.1 Simulate
10.2 Profile
10.2 Profil
10.2.1 Link Mast
10.1.2 Basic Dev
Page 53
Startup
August 2014 POS-UM-00009-EN-02