Configuration Guide

36
Parameter Description
N
PhyCellID Physical Cell Identifier (PCI) of the neighbor cell.
QOffset
Frequency offset this neighbor cell. Indicates the difference
in signal level between the serving and this neighboring
eNB, as
determined by the received signal level at the UE. If
the received signal level is better from a neighboring eNB by
at least this amount of difference in dB, the UE will reselect
this cell.
Range is +24 to -24. A typical value is 0dB.
QRxLevMinOffsetCell
Cell minimum received level offset. This parameter
represents the cell’s minimum received level offset. It is
used only when the UE resides in the VPLMN and cell
selection is triggered due to periodic searches for
high-priority PLMNS. Range is from 1 to 8.
QQualMinOffsetCell
Cell minimum received signal quality offset. This parameter
represents the cell’s minimum received signal quality offset.
Range is from 1 to 8.
CIO
Cell Individual Offset (CIO) is this neighbor eNB’s cell offset,
which is one of the variables used to determine which eNB
will best serve a given UE.
Range is +24 to -24. A typical value is 0dB.
Blacklisted Black list. Range is 0 or 1.
TAC
Tracking Area Code (TAC) of this neighbor cell. Range is
from 0 to 16777215.
eNB Type eNB type. Range is 0 or 1.
eNB ID
The global identity of the E-UTRAN cell. Range is from 0 to
1048575.
No Remove No remove identity. ON or OFF.
5. Click “Save” to complete the setting of the LTE neighbor frequencies and cells.
Configure NR Neighbor Frequency and Cell
7.2
1. In the left navigation column, select “NR Setting >NR Freq/Cell” to enter the NR
neighbor frequency and cell configuration page, as shown in Figure 7-2.