User's Manual

Install on Pole 2.5

Installing on pole have three methods: traditional on pole, telegraph on pole and iron on

tower.

 Traditional on pole: Required diameter of the pole is 25mm to 45mm.

 Telegraph on pole: If the pole is telegraph, you need to install a pole that length is

over 700mm and diameter is 25mm to 45mm as the mounting bracket.

 Iron on tower: If CPE is installed on iron tower, you need to choose vertical direction

angle iron as the mounting bracket. The length is about 25mm to 45mm.

Installation steps is as follows:

1. Loosen iron hold hoop use the screw driver, make the hold hoop through the

mounting hole and fix with the pole.

Figure 2-2 Install on pole A

2. Locking the iron hold hoop use screw driver, fasten the CPE with the pole.

Iron hold hoop