User's Manual

Baicells mBS1105 Base Station Installation Guide(V100R001C00,02).docx

2. Make sure the installation height of the eNodeB, fit the thread rod of the assembled

bracket to the pole, and then pass the omega through the threaded rods, and fasten

the four nuts.

Caution:

The arrow of the installation bracket must be upward.

3. As the following figure, hung the two pin on the eNodeB bracket to the installation

bracket, push the eNodeB until the hook block to the eNodeB bracket

4. Fasten the screw on the top of the eNodeB bracket using cross screwdriver.

5. The installation is complete.