User's Manual

Baicells mBS1105 Base Station Installation Guide(V100R001C00,02).docx

 If the outlet is indoors, place the power adaptor indoors.

 If the outlet is outdoors, place the power adaptor in a water proof box.

4. After the cable connection is complete in the wiring cavity, fasten the screws on the

cover to close the wiring cavity using M4 cross screwdriver.

4.6.7 Connect Ground Cable

Make the grounding cable according the actual situation of the installation site.

The mBS1105 provides two grounding screws, which is located on the bottom of the

base station, as shown in Figure 4-3.

Figure 4-3 Location of Grounding Screws

1. Unscrew one grounding screw, connect one end of the grounding cable to the

grounding screw, and fasten it again.

2. The other end of the ground cable needs to connect to a good grounding point.

Install Antenna Feeder System 4.7

There are two kinds of outdoor antennas, omnidirectional outdoor antennas and

directional outdoor antennas, whose installation will be introduced in the following,

respectively.

4.7.1 Install Omnidirectional Antennas

One should pay attention to the followings while installing the omnidirectional outdoor

antenna:

 The diameter of the pole for omnidirectional outdoor antennas is required to be

35mm ~ 50mm. A typical case is to use the 50mm-diameter round-steel-made pole

(with details depending on the specific antenna type).

 Make sure that the top of pole and the clamp beneath the antenna are at the same

level, after installing the omnidirectional outdoor antenna on the pole.