Installation Guide

Nova-436Q Outdoor LTE TDD Base Station Installation Guide
11
devices. Avoid interference from other transmitting antennas to the GPS antennas.
 Should be installed within 45 degrees to the lightning rod.
The GPS has been assembled before packing, the only installation step is to fix the GPS
mounting bracket on the base station with the M4*14 screws, as shown in Figure 3-2.
Figure 3-2 Install GPS Antenna
Install on Pole 3.4
Required diameter of the pole: 40mm ~ 100mm. Suggest the installation height higher
than 120cm.
The base station bracket has been assembled before packing. In the installation site, the
installation persons only need to fix the assembled base station on pole.
1. Unscrew the four screws of the assembled bracket and slide the two omegas to the
left as the following figure, and then turn the two omegas up or down.
2. Make sure the base station’s installation height, fit the thread rod of the assembled
bracket to the pole, and then turn the two omegas to proper position as the following
figure, and slide the two omegas to the right, and then fasten the four screws.