User Manual

ManualsBrandsBailey ManualsLight FixturesLED Wallpack 45W 4000 K IP65

Technical Specications

Operating voltage / Nom. spanning / Betriebsspannung / Tension nominale AC 100V-240V 50-60Hz

Beam angle / Stralingshoek / Abstrahlwinkel / Angle de diffusion 110°

Operating temperature / Omgevingstemperatuur / Betriebstemperatur / Température ambiante -20 ~ 40°

IP Rating / IP Waarde / Schutzart / Protection IP IP65

Manual - Handleiding

Bedienungsanleitung - Manuel d’instruction

LED Wallpack

www.bailey.nl

A – Tapped holes with metal screw cap suitable for TP Watertight connector (Included)

B – Mounting holes

360mm

235mm

190mm

Caution

• Disconnect power before installation and servicing.

• Make sure the supply voltage is the same as the rated luminaire voltage.

• The product may only be assembled and tted by a qualied electrician.

• Mounting surface must be specied to properly support the weight of the luminaire.

• Suitable for both internal and external use.

• Suitable for wall mounting only.

Installation

1. Switch off the power supply. Open the luminaire by removing the 2 screws on the side. Line up back plate and mark

mounting holes (B) onto surface. Mount securely (gaskets included) and ensure luminaire is installed tight to mounting

surface. Optional:

- Remove front cover by disconnecting connector

- Use metal bracket for wall mounting (included)

2. Select a cable entry and remove the screw cap from the desired mounting hole (A), place watertight connector (included)

and connect power cable to luminaire: Blue to N, Brown to L, Green/Yellow to Ground. If using a junction box, bring the

circuit wires through the rear hole into the luminaire.

3. Close the front cover and tighten the screws securely and make sure wiring is not pinched. Apply silicon sealant (not

provided) to seal all holes in luminaire housing and between housing and mounting surface to weather-proof your outdoor

installation.

Safety – Maintenance - Environment

• Do not cover the product. Do not attach other items to the product. Store and install the product out of the reach of

children. Only use the product when it is working perfectly.

• Do not touch the product in the event of a fault or breakdown. Immediately switch off the product and disconnect the

power supply.

Summary of content (4 pages)

PAGE 1
LED Wallpack Manual - Handleiding Bedienungsanleitung - Manuel d’instruction Technical Specifications Operating voltage / Nom.
PAGE 2
• • • • • The following situations are meant by fault or breakdown: there is visible damage to the product, the product is not working perfectly (e.g. it is flickering), there is a burning smell, the results of overheating are visible. Testing and small repairs must only be carried out by a qualified electrician. In order not to adversely affect the service life, it is advisable to clean the fixture on a regular basis. Only use a soft cloth, water and soap to do so.
PAGE 3
Garantie De garantieperiode begint op de dag waarop het product bij Bailey is aangekocht en eindigt na 2 jaar. Indien er binnen de garantieperiode een defect optreedt als gevolg van materiaal- en/of fabricagefouten, zal Bailey het product repareren of vervangen. De garantie dekt niet de gevolgschade en tevens worden er geen eventuele voorrijkosten, verplaatsingskosten of installatiekosten vergoed.
PAGE 4
Der Garantieanspruch erlischt wenn: • es keine Angaben oder Dokumente gibt, aus denen das Kaufdatum hervorgeht (Rechnung oder Lieferschein); • die Modell- und/oder die Seriennummer auf dem Produkt nicht erkennbar ist/sind (Bild des Produktaufklebers oder des Aufdrucks mit Spezifikationen zusenden); • das Produkt nicht von einem anerkannten Installateur eingebaut wurde; • der Defekt durch falsche oder zweckwidrige Nutzung des Produktes oder durch Nutzung unter extremen Umständen oder in einer Umgebung, in de