Manual

ManualsBrandsBaintech ManualsCaravan & RV120w Folding Solar Blanket

PRODUCT CODE: BTBLANKET120

12 Month warranty

www.baintech.com.au

120W

SOLAR BLANKET

BTBLANKET120

GREAT FOR

Included accessories:

PWM Regulator 6m Power Lead Red Anderson

Connection

Alligator Clamp

Connector

Efficiency Up to 24%

Model 120W (Blue)

Output 5.5V/2A & 18V/6.6A

Solar Cell Monocrystalline Sunpower solar cell

Rated Power 18V 120W

Unfolded Size 1560mm H x 770mm W

Weight 3.6kg

Charge controller 12V/24V 20A solar charge controller

Operating Temp -35� to +55�

Go off-grid with the Baintech 120w Solar Blanket. Designed to charge

your 4WD, RV and Marine batteries, this lightweight and compact

blanket will produce up to 6.6A in optimal conditions.

Designed with ease of use in mind, the simple plug and play Anderson

plug connection is secure, safe and easy to connect.

The Baintech blanket comes with a smart 20amp 12/24v PWM with

chemistry profiles for 3 types of batteries – sealed, GEL, and Flooded

(see separate PWM manual included)

• High efficiency

• Compact

• Light weight

• Easy to use – plug and play

• All accessories and PWM included

BAINTECH 120W

SOLAR BLANKET

Summary of content (4 pages)

PAGE 1
BAINTECH 120W SOLAR BLANKET Go off-grid with the Baintech 120w Solar Blanket. Designed to charge your 4WD, RV and Marine batteries, this lightweight and compact blanket will produce up to 6.6A in optimal conditions. 120W SOLAR BLANKET Designed with ease of use in mind, the simple plug and play Anderson plug connection is secure, safe and easy to connect.
PAGE 2
How to connect the blanket to your devices Warning and Safety Instructions The 120W Baintech solar blanket offers a simple plug and play solution. The blanket comes with a PWM Solar Controller. The Solar Controller is normally used when there is no internal controller in your equipment. ( ie: when you want to charge your car battery, or a secondary battery in a trailer.) Do not drive over the blanket, leave in wet environments - such as rain or sea water, or unattended where wind and theft may occur.
PAGE 3
180W + 120W SOLAR BLANKET ※ Thank you for selecting ViewStar AU series solar charge controller. Please read this manual carefully before using the SOLAR CONTROLLER product. (3)The battery fuse should be installed as close to battery as possible. The suggested distance is within 150mm. (4) The VS AU series is a positive ground controller. Any positive connection of solar, load or battery can be earth grounded as required.
PAGE 4
Battery Overheating Battery level shows current value, battery frame blink, fault icon blink Load failure Load overload ① Temperature sensor is higher than 85℃ Temperature sensor is less than 75℃ Load current ≥2.