Owner's manual

28
Ignition System Check
1- Remove the spark plug and reattach it to the spark plug lead.
2- Turn ignition stop switch to the “RUN” position. Have someone work
the kick start lever. If the ignition system is operating properly, a blue
spark should jump across spark plug gap. If there is no spark, take your
machine to your service center.
COMPLAINT: Engine stalls
1- Make sure there is enough fuel in the fuel tank.
2- Check to see that the spark plug is not fouled. Remove the spark plug
and clean it. Replace it, if necessary.
3- Make sure the fuel valve is not clogged, and the fuel tank is not clogged,
either.
4- Check the idle speed. If necessary, adjust it using a tachometer. The
correct idle speed is 1400~1600 r/min.
5- Make sure the air lter is clean.
WARNING
Performing the spark test improperly could be hazardous.
You could get a high voltage electrical shock if you are not familiar with this
procedure.
Do not perform this check if you are not familiar with the procedure. Do
not point the spark plug near the spark plug hole during this test. Do not
do this test if you have a heart condition or wear a pacemaker. Do not
perform this test is any near any open fuel containers for near fuel which
has spilled on the ground, on the engine, or any part of the vehicle.
TROUBLESHOOTING