Installation Manual

10 ft/lbs
Insert the large
flat bolt with the
supplied rubber
washer through
the front panel
and silver slotted
bracket under-
neath. Repeat
on other side.
BAK Industries • 1100 N. Glenstone Ave. Suite 140, Springfield, MO 65802 • 844-779-8986 • bakindustries.com
Part# 318A0029 Rev. A
6
Place the rear clamp approx 6 inches from tailgate. Tighten
all the clamps until snug. Then torque an additional 1/2 turn
(approx 10 ft/lbs). Repeat steps 2-7 on opposite side.
5
Apply downward
pressure to the
BAKFlip rail when
tightening the clamp
to ensure the rail
sets flush and seals
properly. A second
set of hands
may help.
9
13
Set the cover in the folded position on the BakFlip rails
towards the front of cab with the small panel forward.
11
The small panel faces
forward, toward the cab
and folds down over
the silver brackets. The
front panel must sit just
inside the bulkhead rail
with the seal resting on
top of the rail. Fold the
panel down and align it
so it is setting squarely
on the rails and align
the mounting holes
with the silver slotted
brackets on the rails.
7
Place the 2nd
clamp near the
center of the
rail. See steps 4
and 5 to ensure
the clamp goes
on correctly.
(8’ beds-evenly
space 2 clamps
between ends).
12
10
Install the three
cab bumpers
along the top
edge of the cover
where it meets
the truck cab.
Before mounting the cover on truck, using a screw-
driver install the two buckle ends into pre-drilled
holes on the front header with the provided machine
screws and threaded posts. DO NOT use a screw
gun, securely tighten by hand only.
IMPORTANT
8
Clip prop rods to their
ball mount on the rail.