Rotisserie Ventless Hood MODEL VGH-Series Installation & Operation Manual Serial Numbers 195937 and higher
Warranty Information LIMITED ONE YEAR WARRANTY BKI (The "Company") warrants to the original purchaser that at time of shipment from the Company factory, this equipment will be free from defect in materials and workmanship. Written notice of a claim under this warranty must be received by the Company within ONE YEAR from the date of installation, but no longer than ONE YEAR AND THREE MONTHS from date of shipment from the factory.
Rotisserie Ventless Hood Table of Contents Table of Contents Table of Contents........................................................................................................................................ 1 Introduction ................................................................................................................................................. 2 Safety Precautions..................................................................................................................
Rotisserie Ventless Hood Introduction Introduction Congratulations! You have chosen BKI’s Rotisserie Ventless Global Hood (VGH) system, a state-of-theart unit that filters grease laden air and returns it to the room. The VGH is a simple ventless extraction hood system designed to mount on top of VGG model rotisserie ovens manufactured by BKI. The hood may be shipped on top of new units or retrofitted at a store location.
Rotisserie Ventless Hood Introduction This message indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices. This message is used when special information, instructions or identification are required relating to procedures, equipment, tools, capacities and other special data.
Rotisserie Ventless Hood Introduction Protect Children Keep children away from this equipment. Children may not understand that this equipment is dangerous for them and others. NEVER allow children to play near or operate your equipment. Keep Safety Labels Clean and in Good Condition Do not remove or cover any safety labels on your equipment. Keep all safety labels clean and in good condition. Replace any damaged or missing safety labels.
Rotisserie Ventless Hood ETL Information Failure to adhere to building, fire and electrical codes during installation of this unit could result in death, serious injury or property damage. The authority having jurisdiction, such as the local building inspector or fire marshal, should be consulted prior to installation to insure compliance with applicable codes.
Rotisserie Ventless Hood Installation Installation Unpacking and Handling Inspection for Shipping Damage YOU are responsible for filing all freight claims with the delivering truck line. Inspect all cartons and crates for damage as soon as they arrive. If damage to cartons or pallets is found, or if a shortage is found, note this on the bill of lading (all copies) prior to signing and receiving.
Rotisserie Ventless Hood Installation Wiring Electrocution, equipment failure or property damage could result if an unlicensed electrician performs the electrical installation. Ensure that a licensed electrician perform the electrical installation. In the event of an appliance fire, serious injury, property damage or death could occur if the appliance is powered from a source other than the oven. The hood MUST receive its input power from the rotisserie for which it is mounted on. 1.
Rotisserie Ventless Hood Baffle Grease / Odor Filter These filters will come already installed in the hood. If not, follow the steps below to install the filters. 1. Remove the filter(s) from the plastic bag. 2. Open the hood and filters doors on the front of the unit by pulling on the handles. 3. Observing the “FRONT” marking on the grease filter and facing the control side of the hood away from the blower, slide the filter into the unit as shown.
Rotisserie Ventless Hood Operation Operation Principles of Operation The hood requires a VGG rotisserie power supply, a two-wire connections tapped into the control circuits of the VGG it is mounted to, and the activation of a simple On / Off switch to operate. The wiring change to the VGG ensures that the rotisserie is inoperable until the filter and door switch circuits are satisfied (that is, the filters are present and the door(s) are closed).
Rotisserie Ventless Hood Operation Preparation The following conditions must be met for the Filter Hood to function: • The charcoal odor filter must be installed. • The grease baffle must be installed. • The filters door and hood doors must be shut. • Power must be supplied to the hood from the VGG. Start-Up To start the Filter Hood, press the power “On / Off” rocker switch button to position I. Shut-Down Power to the appliance is turned off, when the hood is turned off.
Rotisserie Ventless Hood Operation an indication to the operators that the filter needs to be changed soon. Theoretically, the hood may be operated with 100% dirty filter (however, hood performance will be affected), as the hood is not designed to shut-down with dirty filters. In low to medium volume applications, the charcoal filter may need replacement prior to the REPLACE FILTERS light illuminating.
Rotisserie Ventless Hood Maintenance Maintenance Electrocution could occur if this unit is hosed down with water. This unit is NOT designed for hose wash-down cleaning! Refer to scheduled maintenance below for proper hood cleaning. Electrocution could occur if power is not removed from this unit before servicing. Remove power at disconnect or circuit breaker BEFORE servicing hood. Scheduled Maintenance Use the following table to help manage scheduled maintenance activities.
Rotisserie Ventless Hood Maintenance Cleaning the Grease Baffle 1. Shut down the unit. 2. Open the front Hood door and Filters door, and slide out the grease baffle from the unit. 3. Spray the grease baffle with degreasing type soap. 4. Rinse with hot water; dry, and replace in hood. Replacing the Charcoal/Odor Filter 1. Shut down the unit. 2. Open the hood door and the filters door on the front of the unit by pulling out on the handles. 3. Slide the used filter out of the unit. 4.
P.O. Box 80400, Simpsonville, S.C. 29680-0400, USA http://www.bkideas.com Made and printed in the U.S.
