Owner`s manual

FLEXIBLE COUPLINGS, CONNECTOR AND CASTERS

For an appliance equipped with casters, the installation shall be made with a connector that complies

with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for

Moveable Gas Appliances, CAN/CGA-6.16, and a quick disconnect device that complies with the

Standard for Quick Disconnect Devices for Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect

Devices for Use With Gas Fuel, CANI-6.9.

If disconnection of the restraint is necessary, make sure to reconnect restraint after the appliance has

been returned to its originally installed position. Domestic gas or water connectors are not suitable.

Restraining device may be attached to the back frame / panel of the unit.

If the appliance is to be installed with casters, a flexible connector must be used and the same ANSI

standards apply. Locking front casters are provided to limit the movement of the appliance without

depending on the connector or associated piping. A suitable strain relief must be installed with a flexible

connector.

All connections must be sealed with a joint compound suitable for LP gas and all connections must be

tested with soap water solution before lighting pilots.

INITIAL PILOT LIGHTING

CAUTION: When lighting pilots and checking for leaks, do not stand with your

face close to the combustion chamber.

All

Bakers Pride appliances are adjusted and tested before leaving the factory, effectively matching them

to sea level conditions. Adjustments and calibrations to assure proper operation may be necessary on

installation to meet local conditions, low gas characteristics; correct possible problems caused by rough

handling or vibration during shipment and are to be performed only by qualified service personnel.

These adjustments are the responsibility of the customer and / or dealer and are not covered by our

warranty.

Check all gas connections for leaks with a soapy water solution before lighting any pilots.

DO NOT USE ANY FLAME TO CHECK FOR LEAKS

Before lighting any pilots, make sure that burner valves and thermostats are turned "OFF".

TOP BURNERS / RAISED GRIDDLE / BROILER

All top section burners are equipped with constant burning pilots. These are to be manually lighted

immediately after the gas is turned on and the system is checked for leaks. Burner pilots are provided

for each burner and can be rechecked for proper adjustment. All adjustments can be made with a screw

driver to the brass pilot valve accessible through the valve cover.

GRIDDLE

The pilot should be lighted immediately after the gas is turned on and the system is checked for leaks.

The pilot can be reached with a long match through the valve cover, or by lifting the plate upward and

accessing through the top. Adjustment of the pilot flame can be made with a screwdriver to the pilot

valve, accessible through the valve cover.

STANDARD OVEN

Pilot gas is tapped from the main burner manifold pipe, routed through tubing to a safety valve, and

then to a pilot burner. Gas flow is controlled by the safety valve.