Operating instructions

ManualsBrandsBakers Pride ManualsConvection OvenBCO-E

The oven, when installed, must be electrically grounded in accordance with local codes and/or the

latest edition of the National Electrical Code ANSI/NFPA No. 70 in the USA (Canadian Electrical Code

CSA Standard C22.1, Part 1 in Canada).

In Europe, the appliance must be connected by an earthen cable to all other units in the complete

installation and, thence, to an independent earth connection in compliance with EN 60335-1 and/or

local codes.

Electrical power is to be supplied to the oven(s) by means of hard wiring, which is to be performed by a

qualified licensed electrician.

Model KW Voltage Phase

Amps

Motor-50hz Motor-60hz

Line 1 Line 2 Line 3 N

RPM

(Low)

RPM

(High)

RPM

(Low)

RPM

(High)

10.5

208

220-240

Each oven requires separate electrical connectionsl

BCO-E, GDCO-E

208

850

1725

Normal factory connections are made for 208 V. A.C. or 208/240 V.A.C., 60 hz.

This unit is provided with a permanently lubricated electric motor. A wiring diagram may be found on the

back of the service panel on the right-hand side and also in this manual.

F. FLUE CONNECTION VENTILATION:

Installation under ventilation hood (standard):

Local inspectors and ventilation specialists should be consulted so that the design and the installation of

the hood conform to local/municipal codes. In the U.K., follow ventilation requirements as detailed in

B.S. 5440.

NOTE: DO NOT PUT A DAMPER IN THE FLUE AND DO NOT CONNECT A BLOWER DIRECTLY

TO THE FLUE.

If the flue runs directly to the free air outside the building, use a wind deflector or a UL listed vent cap at

the end of the pipe. Termination of the vent must be at least two feet above the highest part of the roof

within ten feet. REF: AGA CATALOG NO. XH0474.

G. SYSTEM CHECK- ROTARY CONTROL (standard):

(1) Open the oven door.

(2) Turn Selector Switch to “HI.” The green indicator light near Selector Switch and oven light will

illuminate.

(3) Close the door. Oven lights will go off and fan will run. Make sure fan is rotating clockwise

looking from front.

(4) Press Oven Light switch. Oven light will go on and will go off as switch is released.

(5) Turn the thermostat knob. The amber indicator light near the thermostat will illuminate and the

heating elements will come on.