Operation Manual

~ P.13 ~
6.8 How to manually activate for RCC reception
• Follow the similar steps to activate for appropriate setting mode;
• Toggle “/\” or “\/” arrows to change the default from ‘No’ into ‘Yes – reboot’
• Press [ ] button to confirm reboot, following screen shown up:
• The Frame will be turned off itself 10 minutes for radio controlled clock reception. During these
10minutes, both the screen and the touch-Lit key board will be off. This is normal; the Frame will
wakeup automatically after reception is complete.
Auto RCC Reception Daily Reception
The Viewer undergoes RCC reception at 3:00am, 4:00am, 5:00am and 6:00am everyday. However, this
would only take place with the condition that the Viewer screen is turned off.
Note:
To shut down the screen, press the Screen ON-OFF button on the remote controller. Once a reception
is successful, the subsequent reception will be slipped.
Power down Reception
The Viewer will start auto RCC reception under the following conditions:
a. The main power of the Viewer is shut down;
b. The Viewer didn’t have successful RCC reception for the last 24 hours;
Note:
The reception will repeat hourly until a good reception is performed.
To shut the main power of the Viewer, press the main power switch on the left side panel of the frame
unit.
More about Radio controlled clock
The radio-controlled time is calculated by the Cesium Atomic clock of Braunschweig (official clock of
Germany). Then the time is coded and transmitted from Mainflingen - near Frankfurt - via a signal on
DCF-77 (77.5 kHz). The transmitting range of the signal is 1500 km, which means that most of Westernand
Central Europe is covered by this signal. Within this range the received time is completely accurate.
However, there are many environmental factors affecting the RCC reception, i.e. next to computer
monitors or other electronic devices, seat over metal surface, surrounded by tall buildings, and so on.
The user is recommended to place the atomic clock near the window and face the transmitter in
Mainflingen-near Frankfurt, Germany. There are 2 level of RCC strength indicator in the clock display;
no wave and full wave represent weak signal and good signal respectively.
If there has no wave above the reception tower that means the signal is very weak and the clock
cannot be set by the RCC signal, please try to rotate the frame unit to other windows to seek for a better
RCC reception location. Besides, the RCC signal is the strongest at night, the user can manually set the
clock to local time and leave it overnight to receive the RCC signal automatically. Once the time signal is
received, the wave icon will stay on the LCD, and time and calendar will automatically be updated.
6.9 How to change the setting for COUNTRY
• Use the “/\” or “\/” arrows to navigate the yellow highlight to the ‘COUNTRY’;
• Toggle “/\” or “\/” arrows to change the COUNTRY setting; press [ ] button to confirm.
6.10 How to change the setting for CITY
• Use the “/\” or “\/” arrows to navigate the yellow highlight to the ‘CITY’;
• Toggle “/\” or “\/” arrows to change the CITY setting; press [ ] button to confirm.
(ENG)