Operation Manual

~ P.14 ~
6.11 How to INSTALL REMOTE SENSOR
• Use the “/\” or “\/” arrows to navigate the yellow highlight to the ‘INSTALL REMOTE SENSOR’, press
[ ] button and the ‘Yes’ becomes high lighted into yellow color. Press [ ] button to trigger
installation process.
• The screen turns into sensor searching page.
Prepare you remote sensor to link up with the frame unit by follow the step procedure as descript on
‘Setting procedure to link up with the Frame unit’ When the Frame is able to locate remote
sensor, it will display the temperature and humidity on the appropriate channel position as the below
image.
The frame will display ‘Sensor not found’ for channel failed in registration, and those channels not
being used.
Each time when the frame is activated for installing sensor, it will continue searching for 2 minutes.
Repeat the install sensor procedure once again for extra sensor.
6.12 How to proceed MASTER RESET
• Proceed master reset when unit found malfunction;
• When confirm ‘Yes’, all the setting will return to factory default except the time and date is still
keeping.
Note:
To escape from the SETTINGS menu and return to the Main Menu, press [Esc] key.
7. PC CONNECTION
The 272766/R can be connected to a computer to act as a card reader for file transfer from a memory
card onto your computer’s hard drive.
Windows® Vista™/XP/XP Pro/2000 SP3 Users
No drivers are needed for Windows Vista, XP, XP Pro, Windows 2000 SP3. Your computer will
recognize the 272766/R upon connection of the USB cable.
Windows 98/98 SE/ME/2000/NT Users
This 272766/R is not recommended for Windows NT® or older operating systems such as Windows
98/98SE/ME and Windows 2000 prior to Service Pack 3. Connecting the 272766/R to a computer that is
running any of these operating systems may cause unreliable results and may damage the 272766/R’s
firmware.
USB Connection to Computer:
To connect the 272766/R Viewer to your computer, you will need a standard USB cable, Type a Male
to Type Mini B 5-pin Male (not included).
a. Connect the AC Adapter to the Viewer and press the power switch to ON.
b. Connect the small end of the USB cable to the USB port on the side panel of the Viewer.
c. Connect the larger end of the USB cable to a USB port on your computer.
d. Five drive letters entitled ‘Removable Disc’ will appear under the ‘My Computer’ icon in Windows;
(ENG)