Owner`s manual

LED Flashing Unit is going through its Power-ON routine

LED ON Unit is in its STANDBY mode

When the unit is plugged into a power line, it will stay in the OFF state until the

Standby button is pushed. The LED will then start blinking and the unit will go

through a 50second warm-up sequence. At the end of that sequence it will turn

ON.

Pressing the button again will switch the unit into its Standby mode.

The REX II can be turned OFF by

pressing and holding

the Standby button.

REX II Power-On sequence:

When you turn the REX II On, it will automatically go through a gentle power-on

sequence. This sequence takes 50 seconds, during which time the display and the

Standby LED will be flashing, indicating the status of the unit.

In addition, the blue LED on the Power Module front panel will also light.

1. The number on the display during this time indicates the volume setting. This

will usually start at 000. This setting can be changed during this time by

using the volume knob or Volume Up/Down buttons on your VK-R3 remote

control transmitter. In addition, such functions as Phase, Mono, input

selection and Mute can be changed during this time either from front panel or

through the remote control.

2. Normally the REX II will be

not muted

(Mute LED on the display is OFF) and

will begin playing at the end of the 50 second delay. If so desired, the unit

can be put in the MUTE mode during this delay interval either by depressing

the front panel MUTE switch or by using the MUTE button on the VK-R3

remote control transmitter.

Turning the REX II Off:

The unit can be turned OFF by

pressing and holding

the Standby button. It will

automatically mute.

PHASE button and LED

This button allows the user to invert the absolute polarity of the signal to

compensate for some recordings that are made out-of-phase. The LED indicates

whether the unit is in its INVERTING or NONINVERTING mode. This function is also

accessible via the VK-R3 remote control.

LED OFF Non Inverting operation