Owner`s manual

11
VK-33 PROGRAMABLE FUNCTIONS
The VK-33 programming functions allow the user to optimize the unit
configuration for any particular system set up. The flexible programming facility
defines each signal input with a group of user-selectable parameters that are then
stored in the unit’s memory. Every time a particular input is selected, its unique
combination of parameters is loaded into the operating memory. Programming is
easy and is accomplished through using just two front panel controls -: the
Function button and Volume knob, or corresponding remote control buttons
(Function and Volume Up/Down buttons).
Every unit comes from the factory with a default set of parameters stored in its
memory. This set of parameters is usable for many applications. The default set
includes the following parameters:
BALANCE ZERO
RELATIVE VOLUME ZERO
PHASE Non-Inverting
MONO/STEREO STEREO
MAXIMUM VOLUME 140
FIXED GAIN OFF
DISPLAY COUNTS
INPUT NAMES 1 TAPE
2 TUN
3 CD1
4 AUX1
5 AUX2 or PH1 if the phono card is
installed
The user may at any time, configure the unit to a particular set of system
requirements. For example, input names can be changed to reflect a given
system’s source configuration.