Repair Hints

4.18 Replacing LED power supply module
Required tools:
Torx Bit TX20 6,3mm (1/4") [00340865]
Slotted screwdriver Blade 2.4mm x 0.4mm x 60mm, in
the kit [00341820]
Container min. 200 ml capacity
Valid for appliance variants with Camera in Fridge (CIF).
Electronic modules may be repaired by customer service or authorised
technicians only!
Danger
Risk of electric shock due to live parts!
Danger to life through electric shock in case of improper repair
▶
Electric parts should be repaired by a qualified electricians.
▶
After the repair have a safety test according VDE 0701 or country-
specific regulations performed.
Danger
Risk of electric shock due to live parts!
Death by electrocution
▶
Disconnect appliances from electrical supply at least 60 seconds
before starting repairs.
Caution
Sharp edges!
Cut injuries
▶
Wear protective gloves.
Prerequisite:
Appliance is disconnected from power supply.
Back side of appliances is accessible.
4.18.1 Removing LED power supply module
1.
Notice
Risk of damage!
Defrost water being spilled on the compressor's electronics and con-
nections may damage appliance electronics.
▶
During removal of drainage hose ensure that defrost water will
not be spilled on electronic components.
1. Disconnect drainage hose from water drain outlet (1).
2. Pour defrost water into the container.
3. Disconnect drainage hose from water evaporation tray (2).
Repair
2021-09-30_9001631452 Copyright by BSH Hausgeräte GmbH Page191of769