User manual

25
Faults
A Fault is an indication of a serious error that can affect the operation of the pool system. One of the following
messages will blink on the lower right side of the Wireless Pool Control display when a fault occurs.
AIR SENSOR FAULT The Air Temperature Sensor has failed or has been disconnected.
WATER SENSOR FAULT The Water Temperature Sensor has failed or has been disconnected.
SOLAR SENSOR FAULT The rooftop temperature sensor has failed or has been disconnected.
pH SENSOR FAULT The pH Sensor has failed or has been disconnected.
ORP SENSOR FAULT The ORP Sensor has failed or has been disconnected.
TDS SENSOR FAULT The Conductivity Sensor has failed or has been disconnected.
POC FAULT The Pool Controller has lost communication with the POC board.
Alerts
An Alert will appear on the display during a change in System status, or when System levels are out of user-specified
limits. One of the following messages will blink on the lower right side of the Wireless Poolux display when the System
is bringing an Alert to your attention.
AIR SENSOR FREEZE The air temperature has reached the preselected 34°F - 40°F set by the user.
The Filter Pump & devices configured to be freeze protected will turn on.
WATER SENSOR FREEZE The water temperature has reached the preselected 34°F - 40°F set by the user.
The Filter Pump & devices configured to be freeze protected will turn on.
CHEMICAL FEEDER PURGE The Chemical Feeder is purging (15 seconds). The Filter Pump will not shut off
while this is occurring.
SOLAR PANEL DRAINING The Solar Valve is being held open to allow the solar panels to drain. The Filter Pump
will be held off while this occurs.
pH LOW The pH of the water is below the user-specified low limit.
pH HIGH The pH of the water is above the user-specified high limit.
ORP LOW The ORP of the water is below the user-specified low limit.
ORP HIGH The ORP of the water is above the user-specified high limit.
TDS LOW The TDS of the water is below the user-specified low limit.
TDS HIGH The TDS of the water is above the user-specified high limit.
DIRTY FILTER The water pressure is above the dirty filter detection threshold.
FAULT MESSAGES AND MEANINGS
ALERT MESSAGES AND MEANINGS