Instruction Manual

Front Access Light
Installation Instructions
Model: 59350
Your G/G Front Access Light is designed to provide a chromatherapy system in
your bath / spa and permit the replacement of the bulb from the front.
The Front Access Light has been specifically designed to enhance the
enjoyment of your bath or spa.
Please read and follow all instructions carefully.
IMPORTANT SAFETY INSTRUCTIONS
You should have received safety instructions with your bath / spa. Please read and follow
them carefully.
ELECTRICAL INSTRUCTIONS
WARNING – RISK OF ELECTRICAL SHOCK: Drain bath / spa and disconnect power before
attempting to open lens.
INSTALLATION INSTRUCTIONS
1. Determine a suitable 3.5” flat surface for light placement.
2. Drill a 2.5” hole for the light assembly.
3. Insert the light assembly through the provided gasket and next insert the assembly into the hole.
4. Hand tighten the nut to approximately 15 ft-lbs.
5. Screw the white reflector onto the back of the light assembly.
6. Insert bayonet bulb into socket assembly and insert through reflector and twist lock into place.
7. If desired, a colored filter can be press fit onto the front of the light assembly.
INSTALLATION INSTRUCTIONS FOR OPTIONAL LED BULB
1. Determine a suitable 3.5” flat surface for light placement.
2. Drill a 2.5” hole for the light assembly.
3. Insert the light assembly through the provided gasket and next insert the assembly into the hole.
4. Hand tighten the nut to approximately 15 ft-lbs.
5. Insert the lamp socket assembly through reflector and twist lock into place.
6 .Insert the LED bulb into the lamp socket assembly.
7. Screw the white reflector with mounted LED bulb onto the back of the light assembly.
40164 Rev A July 21, 2009