Owner's manual

54
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
4/22/13
CLEANUP CYCLE (OPTIONAL)
When a pump or blower is turned on by a button press, a clean-
up cycle begins 30 minutes after the pump or blower is turned
off or times out. The pump and the ozone generator will run for
30 minutes or more, depending on the system. On some systems,
you can change this setting. (See the Preferences section.)
MAIN FILTRATION
Using the same navigation and adjustment as Setting the Time,
Filter Cycles are set using a start time and a duration. Each set-
ting can be adjusted in 15-minute increments. The panel calcu-
lates the end time and displays it automatically.
FILTER CYCLE 2 - OPTIONAL FILTRATION
Filter Cycle 2 is OFF by default.
Simply navigate to the Filter Cycle 2 line by pressing the Right
Navigation Button, and when “NO” is highlighted, press Up or
Down to toggle Filter Cycle 2 on and off. When Filter Cycle 2 is
ON, it can be adjusted in the same manner as Filter Cycle 1 by
navigating to the right.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which
will shorten overall filtration by the overlap amount.
PURGE CYCLES
In order to maintain sanitary conditions, as well as protect
against freezing, secondary water devices will purge water from
their respective plumbing by running briefly at the beginning of
each filter cycle.
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter
Cycle 2 will initiate a purge when Filter Cycle 2 is programmed
to begin..
HOLD MODE - M037*
Hold Mode is used to disable the pumps during service functions
like cleaning or replacing the filter. Hold Mode will last for 1 hour
unless the mode is exited manually. If spa service will require
more than an hour, it may be best to simply shut down power to
the spa.
TP800, TP900 Adjusting Filtration
Filter Cycles
Filter Cycle 1
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
Filter Cycle 2 No
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
Back
Filter Cycles
Filter Cycle 1
Starts at 6:15 AM
Runs 3 HR 0 Min
Ends at 9: 15 AM
Filter Cycle 2 No
Starts at 12:00 AM
Runs 0 HR 0 Min
Ends at 12:00 AM
Back
Cancel