Owner's manual

81
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
42211B
Drain Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . 57
Electrical Protection . . . . . . . . . . . . . . . . . . . . . . . 19
Exiting Priming Mode . . . . . . . . . . . . . . . . . . . . . . 52
Exiting Priming Mode . . . . . . . . . . . . . . . . . . . . . . 63
F6 and F8 are on the main board. F1 is located on the expander
board. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
F6 Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
F6 to TB1 Red . . . . . . . . . . . . . . . . . . . . . . . . . . 37
FALT LOG (Fault Log) . . . . . . . . . . . . . . . . . . . . . . 46
FALT LOG (Fault Log) . . . . . . . . . . . . . . . . . . . . . . 65
Fault Log Message Codes: TP400, TP600 . . . . . . . . . . . . 67
Fault Log: tp800, tp900 . . . . . . . . . . . . . . . . . . . . . 57
---˚F ---˚C . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
Filter Cycle 2 - Optional Filtration . . . . . . . . . . . . . . . . 54
Filtration and Ozone . . . . . . . . . . . . . . . . . . . . . . . 53
Filtration Cycle . . . . . . . . . . . . . . . . . . . . . . . . . 74
Flashing Heat LED on TP600 ("Heat Waiting") . . . . . . . . . 20
Flow-Related Checks . . . . . . . . . . . . . . . . . . . . . . 56
Flow-Related Checks . . . . . . . . . . . . . . . . . . . . . . 66
Forcing the GFCI Trip Test . . . . . . . . . . . . . . . . . . . . 58
°F or °C is replaced by °T . . . . . . . . . . . . . . . . . . . . 59
°F or °C is replaced by °T . . . . . . . . . . . . . . . . . . . . 66
Freeze condition . . . . . . . . . . . . . . . . . . . . . . . . . 21
Freeze Protection . . . . . . . . . . . . . . . . . . . . . . . . 53
Fuses installed in the system . . . . . . . . . . . . . . . . . . 32
fuses removed form the circuit. . . . . . . . . . . . . . . . . . 32
GFCI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74
GFCI Failure - System Could Not Test/Trip the GFCI – M036 . 66
GFCI Test (Feature not available on CE rated systems.) . . . . 57
Ground-Fault Circuit Interrupter/Circuit Breaker (G.F.C.I.) . . . 11
Ground in System Enclosure . . . . . . . . . . . . . . . . . . 10
Heater Assembly . . . . . . . . . . . . . . . . . . . . . . . . . 7
Heater Element Specifications Are Shown on the Heater Tube
Label . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Heater Flow is Reduced (HFL) – M016 . . . . . . . . . . . . . 65
Heater Flow is Reduced (LF)* – M017 . . . . . . . . . . . . . 65
Heater Matrix . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Heater May be Dry (dr)* – M028 . . . . . . . . . . . . . . . . 65
Heater Related Messages . . . . . . . . . . . . . . . . . . . 56
Heater Start Up Information . . . . . . . . . . . . . . . . . . 20
Heater Type . . . . . . . . . . . . . . . . . . . . . . . . . . 56
Heater Voltage (Feature not used on CE rated systems.) . . . 56
Heater Voltage (Feature not used on CE rated systems) . . . . 64
Heater Wattage as Configured in Software (CE Systems Only) 56
Heater Wattage as Configured in Software (CE Systems Only) 64
Heat LED in Heat Waiting Mode, TP600 . . . . . . . . . . . . 20
H _ (Heater Type) . . . . . . . . . . . . . . . . . . . . . . . . 64
Hold Mode - M037* . . . . . . . . . . . . . . . . . . . . . . . 54
Hot fault – M035 . . . . . . . . . . . . . . . . . . . . . . . . 59
How the Dolphin Works . . . . . . . . . . . . . . . . . . . . . 71
How to Remove a System Circuit Board . . . . . . . . . . . . 45
How to Replace a System Circuit Board . . . . . . . . . . . . 45
HTR is too Hot (OHH)* M030 . . . . . . . . . . . . . . . . . . 65
If Correct Wiring is Verified . . . . . . . . . . . . . . . . . . . 11
If the problem stays with the same sensor (according to topside
messages) it's a board problem; if the problem moves to the other
sensor it's a sensor problem. . . . . . . . . . . . . . . . . . 44
INFO (System Information sub-menu) . . . . . . . . . . . . . . 64
Language . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
Locking nuts are in the same location on other BP models . . 50
Logic Jumper, No. 20618 . . . . . . . . . . . . . . . . . . . . . 7
Low Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
M0[XX] numbers are Message Codes. . . . . . . . . . . . . . 52
M-7 Replacement Sensor . . . . . . . . . . . . . . . . . . . . 44
Main Filtration. . . . . . . . . . . . . . . . . . . . . . . . . . 54
Measure resistance from a heater post to the heater housing 34
Memory Failure - Checksum Error* – M022 . . . . . . . . . . 66
Memory Failure - Clock Error* – M020 . . . . . . . . . . . . 66
Memory Warning - Persistent Memory Reset* – M021 . . . . 66
Message Codes . . . . . . . . . . . . . . . . . . . . . . . . . 21
Message Codes . . . . . . . . . . . . . . . . . . . . . . . . . 64
Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . 51
MODL (System Model) . . . . . . . . . . . . . . . . . . . . . 64
Most messages and alerts will appear at the bottom of the
Index of Paragraph Topics (cont.)