Specifications

12
2.5 MOTOR CONNECTION: Connect the motor to Terminal Block TB1 (Terminals “U”, “V”,
“W”), as shown in Figure 1, on page 10. (Load reactors may be required for cable lengths
over 100 ft. (30 m) – contact the local Baldor District Office). See Section 4.3, on page 16.
2.6 JUMPER SETTINGS: All jumpers have been factory set for most applications, as shown in
Figure 3, on page 10. Some applications require setting of the jumpers in order to set the
drive for a specific application. Jumper J2 must be set to match the horsepower of the
motor being used. Refer to Table 4, on page 5 and Section 6, on pages 19 - 21.
2.7 60 Hz and 50 Hz MOTOR OPERATION: The drive is factory set for 60 Hz motor operation
(Jumper J5 set to the “60Hz” position). See Section 6.4, on page 20.
2.8 PILOT LIGHT: After applying power to the drive and setting the On/Off AC Line Switch to
the “ON” position, the panel mounted Pilot Light will illuminate.
2.9 DIAGNOSTIC LEDs: After applying power to the drive and setting the On/Off AC Line
Switch to the “ON” position.
2.10 TRIMPOT SETTINGS: All trimpots have been factory set for most applications, as shown
in
Figure 3, on page 13. Some applications require adjustment of the trimpots in order to
setup the drive for a specific requirement. See Section 7, on page 21.
FIGURE 2 – COVER LAYOUT
■ Front Cover Screws
■ Main Speed
Potentiometer
■ On/Off AC Line
Switch
■ Pilot light
■ Provision for
Optional
Forward-Stop-
Reverse
Switch
■ Hole Plug