User Guide

3-6 Operation MN850
Changing the Power–up Settings & Select Keypad Control When the Control Supply (115VAC) power is first
applied, the control loads the parameter settings into working memory. You may change
any of these parameters and operate a motor with the changed settings. However, if
these values are not saved they will be lost the next time power is removed. You can
save the new values as power–up values so they will be loaded the next time Control
Supply power is turned off and turned back on.
Procedure:
Turn Control Supply power on. Use the menu’s and change any parameters to the new
values as desired. When all changes are made, operate the motor to ensure that all
values are as desired. Then, stop the control and perform the following:
Action Description Display Comments
Press ENTER key
APPLICATIONS
AUTO FEATURES
Press ENTER to access menu
mode.
Press ⇓ key several
times
Scroll to the Permanent Store
menu.
PERMANENT STORE
PASSWORD
Press ENTER key Enter level 2 of Permanent Store
menu.
SAVE PARAM
POWER ON PARAM
Press ⇓ key several
times
Scroll to the Default Param menu.
DEFAULT PARAM
Press ENTER key Stores the new parameter values
in permanent memory. Thew
display will flash one time to show
parameters were successfully
saved.
DEFAULT PARAM
Next time power is applied, these
new values will be loaded and
used for motor operation.
Press # key several
times
Scroll to the Basic menu.
APPLICATIONS
AUTO FEATURES
Select Keypad Starting and Keypad Control
Action Description Display Comments
Press ENTER key
APPLICATIONS
AUTO FEATURES
Press ENTER to access menu
mode.
Press ⇓ key Scroll to the Basic menu.
BASIC
ADVANCED
Press ENTER key Enter level 2 of Basic menu.
STARTING (KEYPAD)
START PEDESTAL
Press ENTER key Accept the change to keypad
starting.
STARTING (KEYPAD)
START PEDESTAL
Press # key several
times
Scroll to the Basic menu.
APPLICATIONS
AUTO FEATURES