User Guide

4-6 Parameter Index MN850
Outputs Menu The internal LED, four digital outputs and two analog outputs can be individually defined
as desired. Each digital output can be assigned positive or inverse logic.
Block Title Parameter Description
Outputs LED Available only on size 2 and 3 controls, this Red LED can represent a variety of status
conditions. The LED is located on the control board.
K1 Relay output with Form C (1 N.O. and 1 N.C.) single pole, double throw contacts.
Contacts are rated for 10Amp @ 250VAC.
Parameter 57 contains the parameter number of the status parameter assigned to K1.
Parameter 58 contains the bit location for the K1 output.
Parameter 54 contains the polarity value for the K1 output.
K2 Relay output with Form C (1 N.O. and 1 N.C.) single pole, double throw contacts.
Contacts are rated for 10Amp @ 250VAC.
Parameter 59 contains the parameter number of the status parameter assigned to K1.
Parameter 60 contains the bit location for the K1 output.
Parameter 54 contains the polarity value for the K1 output.
K3 Available with optional I/O expansion board. Refer to MN851 for information.
K4 Available with optional I/O expansion board. Refer to MN851 for information.
Analog o/p1 Available with optional I/O expansion board. Refer to MN851 for information.
Analog o/p2 Available with optional I/O expansion board. Refer to MN851 for information.
Voltage o/p Available with optional I/O expansion board. Refer to MN851 for information.
Parameters Menu Allows quick access to parameter values. Useful to view status or change a value of any
programmable parameter. Refer to Appendix B for parameter numbers and values.
Block Title Parameter Description
Parameters P1 – P20 Entry point for viewing or programming parameters P1 – P20.
P21 – P40 Entry point for viewing or programming parameters P21 – P40.
P41 – P60 Entry point for viewing or programming parameters P41 – P60.
P61 – P80 Entry point for viewing or programming parameters P61 – P80.
P81 – P100 Entry point for viewing or programming parameters P81 – P100.
P101 – P120 Entry point for viewing or programming parameters P101 – P120.
P121 – P125 Entry point for viewing or programming parameters P121 – P125.
Trips Menu This menu is used to view the last five fault trip conditions. Additional information about
fault trips may be found in the troubleshooting section of this manual.
Block Title Parameter Description
Trips 1–16 External Trip Use the “⇑” and “⇓” keys to scroll through the fault trip list. In this example,
1 = the most recent trip (5 would indicate oldest).
16 = the code for the fault trip.
External Trip = the text message for the fault trip.