User Guide

Parameter Index 4-7MN850
Mapping to an Output Relay Most status values are stored in memory as status words.
The following is a list of these status words:
Parameter Description (128)
10000000
(64)
01000000
(32)
00100000
(16)
00010000
(8)
00001000
(4)
00000100
(2)
00000010
(1)
00000001
8 Status 1 Stopping Energy
Saving
Full
Conduction
Dwell Top of
Ramp
Current
Limit
Starting Stopped
9 Status 2 4-20mA level
>P46
DC I/p level
>P48
Inhibit Start Noise on
Power
Forced
Override
Stall Overload
Integrating
Alarm
10 Status 3 Red LED
(Not Used)
Input 3 Input 2 Input 1 Relay K4 Relay K3 Relay K2 Relay K1
51 User Flag 1
(for first Param. set)
Remote
Starting
Not Used Thermistor
Selector
Low
Current
Selector
Shearpin
Selector
Overload
Selector
Current
Limit
Timeout
Kickstart
Selector
52 User Flag 2
(for first Param. set)
Zero Start
Time
Second
Parameter
Set
Main
Contactor
Remote
Start/Stop
Keypad
Start/Stop
Not Global
Enable 2
Not Global
Enable 1
Low
Voltage
Soft–Stop
53 User Flag 3
(for first Param. set)
Auto
Pedestal
Auto End
Start
Auto Stop Auto End
Stop
Inverted
Control
Input
User
Current
Limit
User Flag 2
Polarity
User Flag 1
Polarity
54 I/O Polarity Red LED
Polarity
(Unused)
Input 3 Input 2 Input 1 Relay K4 Relay K3 Relay K2 Relay K1
86 Auto Config 2 Auto
Pedestal
Auto
Endstart
Auto Stop Auto
Endstop
Auto Jog Auto
Bypass
Auto 3MC (Unused)
95 User Flag 1
(for 2nd Param. set)
Remote
Starting
Not Used Thermistor
Selector
Low
Current
Selector
Shearpin
Selector
Overload
Selector
Current
Limit
Timeout
Kickstart
Selector
96 User Flag 2
(for 2nd Param. set)
Zero Start
Time
Second
Parameter
Set
Main
Contactor
Remote
Start/Stop
Keypad
Start/Stop
Not Global
Enable 2
Not Global
Enable 1
Low
Voltage
Soft–Stop
112 Status 4 Thermal
Switch
Overload Timeout Thermistor Under
Current
Shearpin RYB Phase
Sequence
60Hz
Each parameter is an 8 bit word and is used as a bit mask. Any bit of each word can be
assigned to an output relay (K1, K2, K3 or K4).