User manual

5-6 Operation MN1851
There are 7 parts to the setup procedure:
Motor First, select the “Motor Type”. Then select your specific “Motor ID”. All of the
parameters will be entered if your motor is on the list. If your motor is not on the
list, you must define a motor and all of its parameters. If your motor is not listed,
select “User Models” in the Library menu and Then click the General tab and enter
the motor parameters. Click “Download” when finished.
Figure 5-2 Motor Selection Screen
Control The “Control ID” is automatically selected. All of the parameters will be entered if
your control is on the list. Click “Download” when finished.
Figure 5-3 Control Selection Screen