Product Manual

3-6 Receiving & Installation
MN2421
3. Connect the following POW’R LITE cable wires, see Figure 3-6:
a. Yellow wire to 1st terminal (Top).
b. Brown to the 2nd terminal.
4. The Power Cord has a 240VAC connector on one end, the other end has flying leads.
5. Route the Power Cable from the rear of the generator to the Control Box. Connect the
plug to one of the 240VAC receptacles, see Figure 3-7. Use 3 cable clamps provided
to secure the cable to the generator.
6. Be sure to route the flying lead end of the cable down the left side of the generator
(viewed from rear of Genset). Lay the the cable between the trailer frame and
generator base. Use plastic cable ties to secure the cable to the trailer cross members.
7. Pull the cable into the hole in the bottom of the Control Box, see Figure 3-6. Route the
cable as shown inside the box toward the terminal strips.
8. Connect the Power Cord wires to the top left terminal strip of Figure 3-6:
a. Black wire to 1st terminal (Top).
b. Red wire to 3rd terminal.
c. Green wire to 4th terminal (Bottom).
Figure 3-7 Generator Outlets
Power
Cable
Clamp
Plug