Product Manual

Section 4
Operation
Operation 4-1MN2421
Light Tower Setup
WARNING: The mast assembly must remain in the stowed position until the outriggers are properly set to
stabilize the trailer . Erecting the mast without setting the outriggers can cause the light
tower set to tip over when raising the mast.
Before starting the generator, be sure to setup the Light Tower if it is to be used. If the generator
is already running, shut down generator operation before you proceed.
See Figure 4-1 for component identification. Carefully read all instructions before starting.
Figure 4-1 Outrigger Setup
Outriggers Extended
Right Jack
Left Jack
Outrigger Lock
Outrigger
Jack Lock Pin
Outriggers Stowed
1. Locate a suitable, level location (± 5% incline maximum). Do not use the generator on
grades that are greater than 5%. Also be sure there are no overhead wires or
obstructions.
The generator is balanced so the majority of the weight rests on the tow bar (front
Jack). If on an incline, the safest way to position the trailer is to have the tow bar facing
down the incline (front of the trailer lower than the rear of the trailer).
2. Pull the Outrigger Lock for the right jack and fully extend the right outrigger.
Lock the outrigger into position using the Outrigger Lock.
3. Pull the Jack Lock Pin for the right jack and rotate the jack to the vertical position. Lock
the jack in its vertical position using the Jack Lock Pin.
4. Repeat steps 2 and 3 for the left outrigger and jack.
5. Repeat steps 2 through 4 for the optional rear outriggers if installed.
6. With the front trailer stabilization in its fully extended position (Figure 4-1 right view),
adjust the five jacks to level the trailer. All jacks must be in firm contact with the ground
and the trailer must be level so the light tower will be vertical when raised.
WARNING: When erecting or stowing the mast assembly, be aware of the pinch points such as where the
tower structures join or where the cable and winch are located. Careless operation can result
in injury. Keep extremities away from moving parts to avoid injury.
WARNING: Before erecting the mast assembly, be certain that the outriggers are properly set to stabilize
the unit and that they are secure and are not damaged. Erecting the mast without setting the
outriggers can cause the unit to tip over when raising the mast.
WARNING: Before erecting the mast assembly, be certain that there are no overhead wires. Contact with
overhead wiring presents an electrical shock hazard that may cause severe injury or death.
WARNING: Before erecting the mast assembly, be certain that there are no overhead obstructions that
the mast will hit when raising it. Hitting an object (tree limb etc.) may damage the mast or
cause the unit to tip over and may result in injury or property damage.
WARNING: Never move or reposition a light tower when the mast is extended or in the vertical position.
Unless the mast is in its stowed position, it may contact overhead wires or cause the light
tower to be unbalanced or tip over.