Product Manual

Section 5
Troubleshooting and Maintenance
Troubleshooting and Maintenance 5-1MN2421
Flood Light Bulb Replacement
WARNING: Light fixtures become extremely hot during use. To prevent severe burns, do not touch light
fixtures, bulbs or other components until they have cooled and no longer present a burn hazard.
Wear protective clothing when placing the tower in the stowed position after use and do not allow
any person to touch the light fixtures.
WARNING: Before cleaning, inspecting, repairing, refueling or performing any maintenance, always be sure
the engine has stopped and that all rotating parts have also stopped. After stopping, certain
components are still extremely hot so be careful not to get burned.
Refer to Section 4 of this manual or the generator manual for the procedures if you are not
familiar with these steps.
1. Stop the generator.
2. Lower the mast.
3. Tilt the mast down to the stowed position.
4. Wait until the fixtures and bulbs have cooled sufficiently and replace the defective bulb.
Periodic Inspections
Periodically inspect the following POW’R LITE components:
1. Clean the light tower and remove any and all dust, dirt, or other foreign material.
2. Clean the light tower and its components with a damp cloth or sponge.
Never use a water hose or pressure washer as this may damage electrical
components.
3. Replace damaged or missing warning labels.
4. Inspect the winch assembly for wear and proper operation. Replace as necessary.
5. Inspect the winch cable and both end loops for damage. Replace as necessary.
6. Verify mast rotation is smooth (with mast in vertical position). Replace as necessary.
7. Inspect Power Cable tie points, ensure that ties are secure and no part of cable
extends lower than the trailer frame.
8. Inspect all electrical cables for damage and replace as necessary.
9. Inspect four light switches for operation and ensure the protective covers are present
and not damaged. Replace as necessary.
10. Inspect covers for lights are intact and not damaged. Replace as necessary.
Service & Parts Service and parts for your generator can be obtained from an authorized service center.
Please have the following information available prior to contacting the service center:
The model number and serial number of the generator set.
A complete and accurate description of the part (part number if known).
Note: Engine parts can usually be obtained from a local distributor by using the information in the
engine manufacturer’s owner’s manual.