Installation Guide

9. Orient the knob
or lever so the set
screw is pointed
down & toward
the hinges of the
door. Slide the
remaining knob or
lever onto the end of
the spindle until it
touches the adaptor
and secure with set
screw.
Follow Steps #1 through #4 in the Single Cylinder Installation
section before proceeding to Step # 1.
3. Insert (2) #10
screws through inside
cylinder and thread
into outside cylinder.
Place cylinder cap
over inside cylinder
and secure with inside
cylinder ring.
4. Place interior plate
onto door. Thread
retainer onto adaptor.
Do not fully tighten.
Install #8 oval head
screws into door. Do
not fully tighten.
5. Insert key to check
operation of deadbolt.
Tighten all screws and
retainers.
Rotate key again to
check operation of
deadbolt
6. Insert the spindle
into a knob or
lever. Align scribed
mark with correct
door thickness and
secure with set
screw.
7. Orient the knob or
lever so the set screw is
pointed down & toward
the hinges of the door.
Slide the remaining
knob or lever onto the
end of the spindle until
it touches the adaptor
and secure with set
screw.
SINGLE CYLINDER INSTALLATION – CONTINUED
©2007 Baldwin Hardware Corporation, Reading, PA PK.2018
1. a. Carefully break
off cylinder tailpiece at
required mark for your
door thickness.
Caution: Use (2)
pairs of pliers as
shown or tailpiece
will be damaged.
b. Align tailpiece with
slot. Keep tailpiece
vertical and curved
toward right side of hole
as illustrated.
2. Insert the cylinder
into ring. Slide the
cylinder tailpiece into
the deadbolt and place
cylinder & ring into
outside plate.
Keeping tailpiece
vertical and curved
toward right side
of the hole, insert
inside cylinder with
threaded collar into
the deadbolt.
DOUBLE CYLINDER INSTALLATION – CONTINUED
DOUBLE CYLINDER INSTALLATION
CYLINDER
RING
OUTSIDE
CYLINDER
INSIDE
CYLINDER
COLLAR
OUTSIDE
CYLINDER
INSIDE
CYLINDER
TOP VIEW
INSIDE CYLINDER
RING
CYLINDER CAP
1-3/4”
SET SCREW
SPINDLE
TAILPIECE
CYLINDER
2-1/4”
2”
1-3/4”
SLOT
B.
CYLINDER
OUTSIDE
RING
OUTSIDE PLATE
DEADBOLT
OUTSIDE
ADAPTOR
#10 X 1-7/8”
CYLINDER SCREWS
COLLAR
CYLINDER
INSIDE PLATE
#8 x 3/4” OVAL
HEAD SCREWS
CYLINDER
CAP
INSIDE RING
(THREADED)
DUSTBOX
STRIKE
#8 X 3/4” SCREWS
RETAINER
FACE
PLATE
KNOB
SET SCREW
SPINDLE
#8 X 1-1/4”
FLAT HEAD SCREWS
INSIDE
ADAPTOR
ALIGNMENT
BUSHINGS
#10 X 3”
WOOD
SCREWS
REINFORCING
STRIKE
STRIKE
ALLEN
WRENCH
LATCH
DOUBLE CYLINDER INSTALLATION
A.
CYLINDER
TAILPIECE
Consumer Help Line 1-800-566-1986