Installation Sheet

ManualsBrandsBaldwin ManualsHardwarePasadena Left Handed Single Cylinder Mortise Handleset Trim Set

For 1-3/4" doors, fold the yellow lock template

and attach to door using Installation T

emplate

Guide. Mark door at appropriate locations for

lock and trim. MARK APPROPRIATE BACKSET.

(Extra thick door conditions, see General Notes.)

Metal template 8498.000 is available for purchase.

Mark Door

Drill Holes

Drill appropriate holes as indicated on yellow

lock template. DO NOT OVERSIZE HOLES.

Only top two holes are drilled for knob to

knob and lever to lever sets.

Install Lock

Insert Spindle

Size Thumbpiece

Drill two pilot holes for the lock face, adjust the

bevel and install the lock. Shim between the lock

and door on cylinder side as shown to prohibit

the cylinder from pulling the lock case off center.

(Failure to shim the lock may cause the cylinder

to sit unevenly on the surface of the trim.)

For handleset trim install the spindle from the

inside with V groove facing bottom door hinge

and thread the screw and lock washer into

the spindle from the outside. Tighten securely.

For knob to knob and lever to lever sets, install

spindle from outside - go to step 13.

Cut the thumbpiece so that it will fully

engage the lift lever on the bottom of

the lock.

Place the cylinder through the trim. Partially insert

key into cylinder. Thread the cylinder into the lock

until it is against the trim and Baldwin name is

horizontal. For knob to knob and lever to lever

sets - Install aligning bushing and fasten trim with

supplied screws. Remove bushing - go to step 16.

Start the thru-bolts which will hold the

exterior trim. (Use screw cover washer

under the bottom thru-bolt.) Tighten

both securely.

Install Thru-Bolts

Install Cylinder

Thread the cylinder plug into interior side of

lock. Place a strip of tape over plug to keep it

from turning. Notch must be located as shown.

(Double cylinder functions: OMIT THIS STEP.)

Install Cylinder Plug

9 10

Cut

Cut Relief Pockets

Cut the relief pockets 3/8" deep on both

sides for the Latch Hinge, 2-1/2" and 2-3/4"

backset only. (Does not apply for 1" front.)

Metal

Paper

Shim