Installation Guide

1. Install Chassis
Secure chassis to door with screws.
2. Install knob/lever
Centerline
Ligne médiane
Linea central
Fold
Doble
Plier
2-3/8" 60mm
2-3/4" 70mm
Note: use the longer screws supplied in
the Thick Door Kit for 2" (51 mm) up to
2-1/2" (64 mm) doors.
extertior chassis
interior chassis
Please note: Product illustrations may differ
from your product. Installation is the same.
Place knob or lever onto chassis and turn set screw clockwise to secure.
Repeat for knob or lever on the other side.
Full Dummy Knob/Lever Installation Instructions
Fits 1-3/8" (35 mm) up to 2" (51 mm) doors
(Thick door service kits for
2" (51 mm) up to 2-1/2" (64 mm) doors
available through customer service)
www.baldwinhardware.com • Customer Service 1.800.437.7448
The set screws are pre-installed.
They do not need to be removed
prior to knob/lever installation.
TEMPLATE
Door Preparation
If your door requires drilling, use the supplied template below with the door preparation
instructions available at www.baldwinhardware.com
47064 / 01
Copyright © 2011 Baldwin Hardware Corporation
The drilling template must be printed to scale
to ensure correct hole placement. To confirm
correct print scale, the square below must
measure exactly 1" by 1" (25mm x 25mm).
1"
25mm
1"
25mm
1"
25mm
Measure
after printing.