Installation Guide

TEMPLATE
LATCH FACE ASSEMBLY
LATCH INSTALLATION
Install with 1/2" (13 mm) screws.
After the completion of Step 1, install the longer torque blade supplied
in the kit. Proceed to Step 2 and install with longer screws.
Install longer torque blade and
reinstall clip to secure.
UP
UP
Single Cylinder Deadbolt Installation Instructions
Fits 1-3/4" (44 mm) up to 2" (51 mm) doors
(Thick door service kits for
2" (51 mm) up to 2-1/2" (64 mm) doors
available through customer service)
Drive in with hammer.
For Square Corner/
Round Corner
For Drive-In Latch
3. Install Strike
Door Preparation
If your door requires drilling, use the supplied template below with the door preparation
instructions available at www.baldwinhardware.com
1-3/4"
(44 mm)
2"
(51 mm)
2-1/4"
(57 mm)
2-1/2"
(64 mm)
Centerline
Ligne médiane
Linea central
Fold
Doble
Plier
2-3/8" 60mm
2-3/4" 70mm
WARNING: This Manufacturer advises that no lock can provide complete security
by itself. This lock may be defeated by forcible or technical means, or evaded by
entry elsewhere on the property. No lock can substitute for caution, awareness of
your environment, and common sense. Builder’s hardware is available in multiple
performance grades to suit the application. In order to enhance security and reduce
risk, you should consult a qualied locksmith or other security professional.
47039 / 01
Copyright © 2011 Baldwin Hardware Corporation
OR
www.baldwinhardware.com • Customer Service 1.800.437.7448
THICK DOOR KIT INSTALLATION INSTRUCTIONS
(AVAILABLE SEPARATELY)
Supports 2" (51 mm) up to 2-1/2" (64 mm) doors
Do not distort clip.
Ensure clip ts tightly.
The drilling template must be printed to scale
to ensure correct hole placement. To confirm
correct print scale, the square below must
measure exactly 1" by 1" (25mm x 25mm).
1"
25mm
1"
25mm
1"
25mm
Measure
after printing.
Remove backplate.
Snap on collar.
Ensure the latch is inserted
with the word “UP” on top.
Note, for a 1-1/2" (38 mm) diameter
hole, test if latch extends and
retracts. Chisel out area if required.
1. Adjust and install latch 2. Install Trim
Measure your door backset as shown.
For Drive-In Latch
If backset of door measures 2 3/4" (70mm),
adjust latch by rotating face as shown.
1/8" pilot holes
may be required.
Remove clip and torque blade.
Not used with
SmartKey products
Please note: Product illustrations may differ
from your product. Installation is the same.