Installation Guide

6
Note: The Fabric Panel is preset to stop 36” from the
Housing. This posion can be changed to lower the
Fabric Panel as much as 84” from the Housing.
18. 
19UP



See Figure 17
20
DOWN

the EasyShade to the current
Let the EasyShade stop on its own
See Figure 17
21UP and DOWN
simultaneously

See Figure 17
Note: The EasyShade is temporarily in Programming
Mode. The UP and DOWN buons on the
Remote Transmier must be pressed and held to
reposion the EasyShade. When either buon is
released, the Fabric Panel will stop moving.
22DOWN or UP
to adjust the new Down
marked in Step 10Figure 11
CAUTION: Do not let the EasyShade extend more
than 84” from the Housing. See Figure 18.
23STOP (my) 

Down
UP and DOWN




Figure 17
Figure 18
EasyShade
Housing


Housing

Fabric Panel Extension

Cable Guide
Bracket
Leading Bar in

Operang the EasyShade

24
UP and DOWN
24a. Press and release the UP
EasyShade will roll up into the EasyShade Housing
Up stop limit should stop


Appendix A
24b. Press and release the DOWN
EasyShade will unroll from the EasyShade Housing
Down stop limit should stop



Appendix A
25
Figure 2

CAUTION: Do not leave your Motorized EasyShade
extended during windy condions, as the uncontrolled
movement of the extended EasyShade Fabric Panel
could cause damage to the product and surrounding
items. Simply retract the Motorized EasyShade by
pressing the UP Buon on the Remote Transmier.
CAUTION: Do not permit the hand-held Remote
Transmier to get wet as this can aect its proper
operaon. It is recommended to keep the Remote
Transmier indoors when the EasyShade is not in use
or if rain is expected.
CAUTION: The installaon procedure for the
Motorized EasyShade includes the use of Cable
Guides to stabilize the extended Fabric Panel during
normal use. If your applicaon does not permit the
installaon of the necessary Cable Guides or you do
not plan to install them, you must use addional care
to prevent damage to your product. While we do
not recommend installing the Motorized EasyShade
without the supplied Cable Guides, some customers
may determine that their applicaon does not have a
vercal surface to install the supplied Cable Guides as
instructed.
Note: During an electrical outage, you will not have
the ability to operate your Motorized EasyShade.
“Congratulaons, your installaon is complete.”