Use and Care Manual

Contact us for assistance: [phone] | www.balkenehome.com 5
ASSEMBLY
4
5
6
2
Place the Bottom Shelf E upside-down on a soft surface. On the
remaining Middle/Lower Shelf Face I, insert a Dowel 3 into
the hole midway between the 2 Cam Bolts installed in Step 1.
Join the Shelf Face to the front edge of the Lower Shelf as shown
(Shelf Face should form a lip toward the bottom side of the
Shelf), by inserting the hardware of the Shelf Face into the holes
in the edge of the Shelf. Fasten by inserting a Cam Lock Nut 2
(with arrow pointed toward edge) into the hole adjoining each
Cam Bolt, then turning the Cam Lock Nuts clockwise until
secure.
Attach the Support Leg L to the bottom of the Lower Shelf by
aligning the hole in one end with the hole in the center of the
Shelf, then inserting a Large Screw 5 through the top of the
Shelf and into the Support Leg. Tighten securely using a Phillips-
head screwdriver.
Hardware Used:
2 Cam Lock Nut x 2
3 Dowel x 1
4 Medium Screw x 1
2
3
E
I
L
4
G
E
3
4
4
Attach the Bottom Divider G to the Bottom Shelf E by
inserting 2 Dowels 3 into the bottom edge of the
Divider then inserting those into the top of the Shelf as
shown.
To secure, insert 2 Medium Screws 4 through the
indicated holes in the bottom of the Shelf and into the
Divider. Tighten using a Phillips-head screwdriver.
Hardware Used:
3 Dowel x 2
4 Medium Screw x 2
D
E
1
F
G
2
Insert and tighten a Cam Bolt 1 into each of the 2
indicated holes in the bottom of the Middle Shelf D.
Slide the Bottom Divider G onto the Cam Bolts.
Fasten by inserting a Cam Lock Nut 2 (with arrow
pointed toward edge) into the hole adjoining each
Cam Bolt, then use a Phillips-head screwdriver to
turn the Cam Lock Nuts clockwise until secure.
Hardware Used:
1 Cam Bolt x 2
2 Cam Lock Nut x 2