Use and Care Manual

ASSEMBLY

Place the Top Shelf C

upside-down on a soft

surface. Insert and tighten Cam Bolts 1 into

the 2 indicated holes near the center of the

Shelf.

Hardware Used: 2 Cam Lock Nut x 2

3 Dowel x 5

5 Large Screw x 6

Insert a total of 5 Dowels 3 into the indicated

holes in the top edge of the Left/Right Sides A/B

and the middle of the

Upper Shelf Face H.

Slide the Upper Shelf Backer J into the grooves at

the rear of the Left/Right Sides.

Lower the Top Shelf onto the partially-assembled

unit by inserting the Cam Bolts into the Top

Divider F while sliding the Dowels into the

corresponding holes in the underside of the Top

Shelf.

Fasten the Cam Bolts by inserting a Cam Lock Nut

2 (with arrow pointed toward top edge) into the

holes in the side of the Top Divider adjoining each

Cam Bolt, then turning the Cam Lock Nuts

clockwise until secure.

Insert 6 Large Screws 5 through the Left/Right

Sides and Upper Shelf Face upwards into the

underside of the Top Shelf. Tighten securely using

a Phillips-head Screwdriver.

Hardware Used: 1 Cam Bolt x 2

Check that all hardware is firmly tightened.

Your Greenwich Media Console is ready for use!