Datasheet

BES 516-3044-G-E4-C-PU-02
Ordering code: BES00M3
Inductive sensor
D03.0x27 mm
Small housing
DC, direct current
PNP/Normally open (NO)
Sn = 1 mm
Flush (shielded)
Characteristic data
Eff. switching distance Sr 1 mm
Tolerance Sr ±10 %
Assured operating distance Sa 0,8 mm
Hysteresis H max. (in % of Sr) 15 %
Repeat accur. R max. (% of Sr) 5 %
Ambient temperature -25...70 °C
Temp. drift max. (% of Sr) 10%
Switching freq. f max. 2000 Hz
Ready delay tv max. 10 ms
Utilisation category DC 13
Function indicator Yes
Power-on indicator No
Short-circuit protected Yes
Degree of protection as per IEC 60529 IP67
Protected against polarity reversal Yes
Protected against reverse connection Yes
Electrical data
Operating voltage
Rated operating voltage Ue DC 24 V
Ripple max. (% of Ue) 10 %
Voltage drop static max. 2,5 V
Rated insulation voltage Ui 75 DC V
Effective operating current Ie 100 mA
No-load current Io damped 12 mA
No-load current Io undamped 9 mA
Off-state current Ir max. 50 µA
Minimum operating current Im 0 mA
Rated short circuit current 100 A
Output resistance Ra Open emitter
Principle of operation Inductive
Mechanical data
Housing material Stainless steel
Sensing surface material POM
Connection type Cable
Cable jacket material PUR
Cable diameter D max. 2,4 mm
Cable short designation LiFY11Y-O
Cable length 2 m
Number of conductors 3
Conductor cross-section 0.09 mm²
Shock rating Shock, half-sinus, 30 gn, 11ms
Vibration rating 55 Hz, 1 mm ampl., 3x30 min
Degree of contamination 3
Basic data
Basic standard IEC 60947-5-2
Remarks
The sensor is functional again after the overload has been eliminated.
EMC: EMC protection circuit needed, see 825345. Burst: 1.2 IVW: 2.2
ESD: EN 61000-4-2, 2 kV contact discharge
Internet
Balluff Germany
Balluff USA
Balluff China
: www.balluff.com
: [phone], 173-370
: 1-800-543-8390
: [phone]
1 (2)
Print date: 02.06.2012
Selection date: 02.06.2012
Definitions see main catalog
subject to change