User's Manual

ManualsBrandsBalluff ManualsElectronicsNon-Contact Read/Write System

english

Parametering Bytes

User-Parameter Bytes

For parametering all 6 bytes must always be transferred in Hex. Only the bits men-

tioned may be changed. No guaranty will be given for the proper functioning of the

BIS L-60_2 if any of the other bits are changed.

The default values (factory setting) for the 6 bytes are:

1st byte 2nd byte 3rd byte 4th byte 5th byte 6th byte

EX 00 80 00 82 00 02

Binary 000

00000 10000000 00000000 10000010 00000000 00000010

bit 4 bit 1...8 bit 7 bit 1 bit 4 bit 1...8

bit 5 bit 5 bit 8 bit 2 bit 5

The bits which serve for parametering have the following functions:

1st byte, bit 5, Activate CRC_16 data checking

2nd byte, bit 5, Dynamic mode on read/write head 1

(for effects on read/write times, see

51)

2nd byte, bit 4, Activate Auto-Read function starting at specified address after CT present

for Head 1 (the number of bytes read depends on the selected buffer size

minus bit headers for Head 1)

3nd byte, bit 1...8 Select data-carrier model for processing:

00Hex: All data-carrier models

Hex: Mifare: All Mifare data carriers supported by Balluff.

Hex: ISO15693: All ISO15693 data carriers supported by Balluff.

Function Description

Parametering, Parametering Bytes

Bit state: 0 = no

1 = yes

These are used for

configuration:

Having the following

functions:

Please note the

basic procedure on

12 and 30...36

and the examples

on pages

37...50.

L60_2-019_828132_1007-e.p65

english26

4th byte, bit 8, Arrange a 2nd bit header at the end of the input and output buffers

If this function is selected, then the minimum size of both buffers is 4 words (8 bytes) each.

4th byte, bit 7, Display state of the digital input in the bit header of the input buffers:

0 = no

1 = yes Input is Low: "IN" in the bit header of the input buffers = 0.

Input is High: "IN" in the bit header of the input buffers = 1.

4th byte, bit 2, Reset the BIS L-60_2 processor through the digital input:

0 = no

1 = yes Input is Low: Do not reset.

Input is High: Reset.

4th byte, bit 1, Output data-carrier model and serial number at CT present:

0 = no At CT present the first data carrier data are output on Profibus.

1 = yes At CT present the data carrier model and serial number (UID = unique ID)

are output on Profibus. A distinction is made between type 01 with a

4-byte UID and type 03 with a 5-byte UID.

5th byte, bit 5 Dynamic mode on read/write head 2