User's Manual

english

6th byte, bit 1...6 No. of bytes in input and output buffer which shall be used for

read/write head 1, see example on

The specification for the input and output buffer on the Master applies to both read/write

heads, i.e. this buffer must be divided for both heads. The specification is done in Hex format

and must be in a range between 02

Hex and 80Hex (128 dec.).

If only one read/write head (Head 1) will be used, you may enter the same value here as for the

total buffer size. An entry of less than 2 bytes results in an undefined state.

Please note the basic procedure on

12 and 30...36 and the examples on pages 37...50.

Parametering Bytes

User-Parameter Bytes

(continued)

Function Description

Parametering, Parametering Bytes

☞

L60_2-019_828132_1007-e.p65

english28

Data-carrier models

BIS L-10_-01/L

CT present

Model BIS L-10_-01/L data carriers have a memory capacity of 192 bytes of user data.

These data can be read or programmed. These data carriers also have a unique, 4-byte

serial number, which is read-only.

The data carrier also contains additional memory ranges for configuration and protected

data. These areas cannot be processed using the BIS L-60_2 processor.

Model BIS L-10_-01/L data carriers are supplied with FF

Hex 37Hex configuration. Only data

carriers having this configuration are processed.

At CT Present the first user data are read from the data carrier and stored in the Profibus

input buffer (see

31). If the “Output data-carrier model and serial number at CT present”

function is enabled, model 01

Hex is output in Byte 1 of the input buffer and then the 4 bytes

representing the unique serial number.

The full command set of the BIS L-60_2 processor can be used with model BIS L-10_01/L

data carriers.

When using model BIS L-10_-01/L data carriers, the device parameterizing depends

mainly on the number of bytes to be read and programmed per head.

Please refer to 13ff and 23ff.

Functions

Device parameters

☞

Data carrier

BIS L-10_-01/L