User Manual Part 1

Configuring the Menu

LRP2000 Long Range Passive Reader/Writer

Delay Between Identical Decodes (0-60)

The Delay Between Identical Decodes parameters can have a value

of 0 to 60 seconds. When the Delay Between Identical Decodes is set

to 0, the LRP2000 will continuously read AND transmit tag data to the

host. This can flood the buffers and cause communication errors and

data loss.

Raw Read Response

If you have selected ABx Fast or ABx ASCII, you have the option of

stripping the command protocol from the data and adding a terminator

to separate the data packets. You can choose a CR (0DH) or CR/LF

(0DH, 0AH) to terminate the data.

Set RF Communication

The LRP2000 should be configured with the default (0) Fast Mode.

*** Set RF Communication ***

RF Communication? [0] Fast Mode* [1] Standard Mode 0

Save Changes to EEPROM? [0] No [1] Yes

Restore Factory Defaults

It is often helpful during troubleshooting to restore the LRP2000 to

known default values. To do so, select 5 from the "[1] Set-up

Operating Parameters" menu .

*** Restore Factory Defaults ***

Restore Factory Default? [0] No [1] Yes

The restored defaults will be saved to the EEPROM. The

communication defaults can also be restored by placing the main

board DIP switch number 5 in the ON position and then restarting the

LRP2000. After you have saved any changes, you must re-initialize

the LRP2000 with switch 5 in the OFF position.

Return to Main Menu

When you have completed your configuration, entering 6 will return

you to the initial menu. Unsaved changes will be effective until the

LRP2000 is reset. Saved changes will be loaded automatically the

next time the LRP2000 is reset, or upon selection of "[4] Exit to

Operating Mode" from the main menu.