User Manual Part 1

LRP2000 Long Range Passive Reader/Writer

• A Host Computer With RS232 Serial Interface for Configuration

• A Host Computer with RS232, RS422, or Ethernet Interface for

Operation (The Ethernet interface is available as an option on the

LRP2000)

• AC Power 120VAC, 60 Hz, 5.0 Amp max 230VAC, 50 Hz, 2.6 Amp

max

1.3 FCC Compliance

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

1.4 Changes and Modifications

Any changes or modifications to the LRP2000 not expressly approved

by Escort Memory Systems, could void the user's authority to operate

the equipment.