User Manual
Table Of Contents
- LRP76 Long Range Passive Reader/Writer
- Table of Contents
- Getting Started
- Mechanical Specifications
- Power and Electrical Interface
- Configuration Menu
- Standard RFID Interface
- 5.1 Introduction
- 5.2 Command Timeout Values
- 5.3 Address Blocks
- 5.4 ABx Error Codes
- 5.5 Command Descriptions
- 5.6 ABx Standard Commands
- 5.6.1 Command 4 (04 Hex): Tag Fill
- 5.6.2 Command 5 (05 Hex): Block Read
- 5.6.3 Command 6 (06 Hex): Block Write
- 5.6.4 Command 7 (07H): Read Tag Serial Number
- 5.6.5 Command 8 (08 Hex): Tag Search
- 5.6.6 Command D (0D Hex): Start/Stop Continuous Block Read
- 5.6.7 Command E (0EH) Read SN and Data
- 5.6.8 Command F (0FH) Start/Stop Continuous Read SN and Data
- 5.7 ABx Fast Commands
- 5.7.1 ABx Command Packet Structure
- 5.7.2 Command 4 (04 Hex): Tag Fill
- 5.7.3 Command 5 (05 Hex): Block Read
- 5.7.4 Command 6 (06 Hex): Block Write
- 5.7.5 Command 7 (07H): Read Tag Serial Number
- 5.7.6 Command 8 (08 Hex): Tag Search
- 5.7.7 Command D (0D Hex): Start/Stop Continuous Block Read
- 5.7.8 Command E (0EH) Read SN and Data
- 5.7.9 Command F (0FH) Start/Stop Continuous Read SN and Data
- Technical Specifications
- Models and Accessories
- ASCII Chart
Standard RFID Interface
44 LRP76 Long Range Passive Reader/Writer
5.7.6 Command 8 (08 Hex): Tag Search
DESCRIPTION
Check to see if there is an RFID tag in the LRP76 field.
DISCUSSION
This command will activate the reader/write to "look" for a tag in the
RF field. If the LRP76 finds a tag it will return a command echo to the
host. The timeout value is given in 1 msec increments and can have a
value of 1EH to FFFEH. If no tag is present it will return an error
message.
Field Description
Header <STX><STX>
Command Size Packet length in bytes, excluding the header,
command size, checksum and terminator bytes.
Command 08H
Timeout 2-byte timeout value given in 1 ms units (1EH -
FFFEH)
Checksum optional checksum
Message
Te r mi n at o r
FFFFH