Quick-Start Guide

Should you require assistance during assembly,
please call our Customer Service Department
Monday - Friday 8 a.m. - 5 p.m. Central Standard Time
Toll-Free Customer Service 1-800-749-2258
The Balt product you have purchased is guaranteed against material and workmanship defects.
This guarantee extends 1 year from date of purchase. Should this product fail to function satisfactorily under normal
use due to defect or imperfection, the defective part or product will be replaced.
Damage caused by common carriers during shipment is not included in this guarantee.
This guarantee sets forth all applicable guarantees and remedies. No other warranty, expressed or implied shall apply.
Failure to follow instructions found in Important Information Section of Owner Sheet shall void the guarantee.
Consequential or incidental damages and or costs are not refundable.
Important
1. FOR LARGE PRINTERS
Attach 2 Long Metal Plates (P-3)
[through outer holes] and 4 Short
Metal plates (P-4) to the Leg Frames
using 4 Screws (A1), 4 Flat Washers
(K) and 4 Wing Nuts (J).
Note: Long Metal Plates should be
attached with Channel side down,
and Short Metal Plates with the
channel side up.
2. FOR EXTRA STABILITY
WITH LARGE PRINTERS
Attach the Long Metal Plates (P-3)
and Short Metal Plates (P-4) same
as for the large Printers. Then attach
Short Metal Plates through the inner
holes on the Long Metal Plate using
4 Screws (A1), 4 Flat Washers (K)
and 4 Wing Nuts (J) for added
stability.
3. FOR NARROW PRINTERS
Attach 2 Long Metal Plates (P-3)
[through outer holes] to the Leg Frames
using 4 Screws (A), 4 Flat Washers (K)
and 4 Wing Nuts (J).
Then attach 4 Short Metal Plates (P-4)
through the inner holes on the Long Metal
Plate using 4 Screws (A1), 4 Flat Washers
(K) and 4 Wing Nuts (J).
P-4
P-3
Outer Hole
Outer Hole
Inner Hole
P-4
P-3
P-4
P-3
A1
K
J
OPTION # 2
OPTION # 1
OPTION # 3