Assembly Instructions

ManualsBrandsBalt ManualsBoards & EaselsIndoor Enclosed Bulletin Board Cabinet,2-Door 60"W x 36"H, Silver Trim, Pacific Blue

Table Of Contents

Which board assembly instructions should you use?

Use L-Clip instructions for...

Use Z-Clip instructions for...

Ultra Trim

Presidential Trim

31 Trim

Euro

Trim

Scroll down for instructions.

ABC Trim

Aluminum Trim

Deluxe Wood Trim

48 Trim

Summary of content (5 pages)

PAGE 1
Which board assembly instructions should you use? Use L-Clip instructions for... Use Z-Clip instructions for... ABC Trim Ultra Trim Aluminum Trim Presidential Trim Deluxe Wood Trim 31 Trim 48 Trim Euro Trim Scroll down for instructions.
PAGE 2
Z Clip Install Instructions Wall Stud Top Edge of Board B dL oar oc n atio Note: Install Masonry Anchors (D) into 1/4” Diameter predrill holes for masonry walls. 3/4 Draw line 3. D Install Drywall Anchors (E) into 1/4” Diameter predrill holes for sheet rock walls. 1. Lift, Tilt, and Slide Board down over the Z-Hangers. Z-Hangers should catch in the top trim on the back of the board. Draw line along bottom edge of board.
PAGE 3
L Clip Install Instructions Wall Stud B d oar at Loc ion Note: Install Masonry Anchors (D) into 1/4” Diameter predrill holes for masonry walls. Install Drywall Anchors (E) into 1/4” Diameter predrill holes for sheet rock walls. 1 41 Draw line D Top Edge of Board Drill Holes E 1 Bo Draw line Bottom Edge of Board 1 Determine board location. Measure from floor to the bottom edge of board. Mark with pencil line the corner location.
PAGE 4
Attention Please read and follow these instructions! Failure to follow these instructions will void your warranty and could result in board failure and possible injury. 1. Always use the correct supplied mounting hardware for the type wall your board will be mounted on. 2. Use the correct stated predrill for the type anchor you will be using. 3. The Angle Brackets and Z Clips MUST be installed according to the layout and spacing as shown below. NOTE: For more information, please refer to our web-site: www.
PAGE 5
Proper L-Clip Layout Your top and bottom L-Clip layouts should be spaced like this for an 8’ wide board. If you don’t use this number of L-Clips on top and bottom, your board could end up like this. Please follow these installation directions.