Operation Manual

2
Operation Manual
ACCESS100
Covered Models:
10023-155-51
10023-001
10023
The “ACCESS100” is a multifunctional contactless smart card RFID Read-/Write-Device (short:
reader).
The reader supports Mifare, ISO14443A/B, ISO15693 and all cards compliant to these standards. It
provides serial interface RS485/ RS232 or a Wiegand Interface to exchange data with a host
computer and a 13.56MHz inductive interface to supply power to and exchange data with the
Mifare/ISO compliant card (or other available form-factors such as tags, key-fobs).
Mounting and Connection
The reader generates a magnetic field with the frequency of 13.56MHz which is influenced by any
electrically conductive material in close proximity to the device. When mounting the unit, a
distance to any such material of minimum 20 mm is required to ensure that there will be no
significant degradation of the performance in terms of read range and reliability. Mounting the unit
directly to metal would result in a severe reduction of read range down to zero functionality. Care
should be taken when testing the device after mounting at a problematic environment: Read ranges
and performance vary from card to card and very much from card to tag or key-fob.
When mounting multiple readers, the distance between readers should be minimum 0.5 meters in
order to avoid degradation of performance due to interference.
The reader provides an attached cable to connect the device to the host computer. The cable is
colour coded as follows:
Pinning
Rear View Reader PCB